Driveshafts & CV Joints

Driveshafts Centre is a pioneer in the driveshaft and constant velocity (cv) joint market in South Africa. Our customers include many of the major car dealerships like Audi, BMW, Ford, Honda, Hyundai, Mazda, Toyota, VW and others. We have knowledgeable and friendly staff and are able to provide a valuable and timeous service to our customers.

Driveshafts are commonly found on front wheel drive, all-wheel drive and 4×4 vehicles. The main function of the driveshaft is to transfer the engine’s power from the gearbox to the vehicle’s wheels. Driveshafts consist of a wheel side cv joint, gearbox side cv joint and the connecting shaft. This system must be able to compensate for any variation in angle and length caused by movement in the suspension and by steering.

Some driveshaft designs also make use of carrier bearings while others may have torsional dampers. Many vehicles’ ABS (anti-lock braking system) functions by means of an ABS ring connected to the cv joint and a sensor which is connected to the vehicle’s computer and which monitor’s wheel lock under braking.

We recommend that driveshafts be serviced every 40 000km to 60 000km as this will extend the life of the components and can save costs in the long run. It is also very important to regularly check that the cv boots are in good condition and are not damaged or leaking grease. The grease inside the cv boot lubricates the moving parts inside the cv joint and should be of adequate quantity, good quality and free of contaminants. Driveshafts will quickly wear or be damaged if not adequately lubricated.

So, what are the common indicators of problems with a driveshaft or cv joint? When cv joints on the gearbox side of a vehicle are worn, the driver would normally experience vibrations when accelerating. Wear on the wheel side cv joints normally causes a TUK-TUK noise when turning. It is best to give immediate attention to driveshaft and cv joint problems to ensure that the vehicle is safe and to prevent a breakdown or possible damage to the vehicle.

We further offer very good quality cv boots which will far outlast most aftermarket cv boots available today. We also offer thermoplastic cv boots which are more resistant to damage, and which carries a one year warranty. CV boots made with Hytrel thermoplastic polyester elastomer resin may for example be a good choice for 4×4 vehicles which are used in off-road conditions and where the cv boots are prone to damage by bushes, branches or other objects.

Customers can contact any of the branches for more information or you can click here if you would like to book a free check-up for your vehicle.

Please see below for other products and services which we offer.